The CS1N-RF is a Boundary layer single element condenser microphone with a half cardioid polar pattern in satin nickle. Minimise the number of microphones on the conference table whilst maintaining high performance and ease of installation. Designed to be placed in the middle of the conference table, with the participants facing the condenser element. The design accommodates both side and bottom cable exits which means it can be used for either mobile and permanent applications. Inbuilt Phantom Power Module. The microphone is be made from solid brass, and capable of being permanently mounted with the use of an M 10 x 1 hollow bolt, nut and washer. The microphone includes a 6.6 ft (2 metre) cable with open-ended termination. Also include is an integral phantom power adaptor PPA-RF which accepts 9 to 48 volts DC. The phantom power adaptor includes filters which will eliminate all GSM frequencies.
Immune to RF artefacts
Boundary layer condenser microphone
Half cardioid polar pattern
Fully balanced
High quality engineering in solid brass
Finish Satin Nickel
Inbuilt Phantom Power Module
Microphone Connectivity - Wired
Microphone Type - Boundary
Microphone Type - Condenser
Polar/Pickup Pattern - Half-cardiod
Spec Sheet available - Yes
Maximum Frequency Response (Bandwidth):
18 kHz
Maximum Frequency Response (Bandwidth):
18000 Hz
Minimum Frequency Response (Bandwidth):
50 Hz
Minimum Frequency Response (Bandwidth):
0.05 kHz
Impedance:
200 ohm
Maximum SPL (Sound Pressure Level):
125 dB
Sensitivity:
47 dB
Signal to Noise Ratio:
64 dB
Wireless:
No
DC Voltage:
48 Volts
Sensitivity:
47dB +/- 3dB at 1 KHz (0dB = 1 V/Pa)
Phantom Power:
9 to 48 Volts
Termination:
Open ended
Finish:
Satin Nickel
CS 1-RF
- Boundary Layer Microphone, Microphones Minimize, High performance and Installation
CS 1S-RF
- Boundary Layer Dual Element Condenser Microphone with Inbuilt Electronic Touch Switch, Black Nextel Finish